Product Overview
ASP’s UV SMART™ D60 System uses UV-C light to deliver automated, chemical-free high-level disinfection of compatible channel-less ENT endoscopes and transesophageal echocardiography (TEE) probes in a 60-second cycle. Automatic cycle records support traceability and audit readiness.
The D60 System disinfects the external surfaces of compatible equipment. Before disinfection, equipment must be pre-cleaned and leak tested according to the applicable manufacturers' instructions for use.
The D60 System is compatible with equipment from major manufacturers. To check a specific device model, visit the D60 System compatibility site.
How to use the UV SMART™ D60 System
-
Pre-clean the equipment and perform a leak test according to the applicable manufacturer’s instructions for use.
1Prepare Equipment
-
Scan your ID and the equipment for traceability.
2Scan Identification
-
Place the equipment in the D60 System and close the door, following the instructions for use.
3Load Equipment
-
Wait 60 seconds for the disinfection cycle to finish.
4Run the Cycle
-
Scan your ID to unlock the D60 System.
5Scan to Unlock
-
Disinfect your hands before removing the equipment.
6Disinfect Hands
-
Remove the equipment, ready for use.
7Ready for Use
DISCLAIMER: This guide is not intended to replace the Instructions for Use (IFU). Prior to use, read and follow the full IFU as the featured steps may not include the complete steps of the procedure. Individual surgeon preference and experience, as well as patient needs, should always dictate variation in procedure steps.
Traceability That Supports Your Team
The D60 System automatically records disinfection cycle information to support traceability.
Automatic Cycle Records
- Full traceability including Operator ID, Instrument ID, Patient ID number, UV-C dose monitoring, and date & time.
- Cycle records are stored in the D60 System’s internal memory.
- Recorded information supports traceability and audit preparation.
Connected Information
When the D60 is connected to your facility’s intranet, the reprocessing information can be viewed on a desktop-installed license of UV SOFT or sent to the Hospital Information System (HIS). This way, you are always up to date and auditable.
Seamless Traceability with UV SOFT™ Software
Capability | D60 System | D60 System |
|---|---|---|
Annual Maintenance Supports consistent operational efficiency. | Included | Included |
Audit Readiness Automatically maintains cycle records to support audits and reduce manual recordkeeping. | Included | Included |
Readily Available Traceability Enables remote access to up-to-date reprocessing information. | Not included | Included |
UV SMART™ D60 System
H: 2033 mm
D: 473 mm
Instructions for Use (IFU)
Device Compatibility
The UV SMART™ D60 System is compatible with a range of ENT endoscopes and TEE probe models. Visit the D60 System compatibility site to check whether your specific probe model is compatible.
Frequently Asked Questions
No. The D60 System is intended for compatible ENT endoscopes and TEE probes without a working channel. It disinfects external surfaces only and does not disinfect internal channels.
No. The D60 System disinfects one device at a time.
Yes. Compatible rigid ENT endoscopes without a working channel can be disinfected in the D60 System. Check the D60 System compatibility page for your specific device model.
The D60 System requires a standard electrical connection suitable for its rated supply of 110–120 V AC or 220–240 V AC. An Ethernet connection to the facility’s intranet enables additional traceability connectivity. Consult the instructions for use for installation requirements.
Yes. Equipment must be pre-cleaned according to the equipment manufacturer’s instructions for use before disinfection in the D60 System. Follow the applicable leak-testing requirements.
Literature
DISCLAIMER: This page provides product information and does not replace the applicable Instructions for Use (IFU). Before use, read and follow the D60 System IFU and the equipment manufacturer’s instructions for cleaning, leak testing, handling and compatibility. The D60 System disinfects the external surfaces of compatible channel-less ENT endoscopes and TEE probes; it does not disinfect internal channels. Product availability and approved indications may vary by country.